HALO 5-Stage Reverse Osmosis

Drinking Water Purification

 

​

HALO RO5

Five Stage Reverse Osmosis Purification System Plus pH Balancer

 

HALO RO 5-Stage Reverse Osmosis System

Addresses specific contaminants in your municipal or healthy water and has been tested and certified by NSF International against NSF/ANSI Standard 58 for the reduction of:
PFAS, PFOS, arsenic, barium, cadmium, copper, fluoride,
chromium (hexavalent), lead, radium 226/228, selenium,

trivalent chromium, turbidity, and TDS.

 

System Summary

This includes the complete system: housings, cartridges, mounting bracket, quick connections, three gal storage tank, tubing, chrome faucet, and installation guide. Faucets are available at an additional cost.

​

Capacity: 50 Gallons

Dimensions: 15” x 18” x 8”

Stage 1: Sediment Filter - 5 microns Filter replacement 6/12 mos.

Stage 2: Carbon block pre-filter - 5 microns Filter replacement 6/12 mos.

Stage 3: Carbon block filter - 5 microns Filter replacement 6/12 mos.

Stage 4: TFC RO membrane - 5 microns Filter replacement 6/12 mos.

Stage 5: High capacity Alkaline Cartridge

                   • Increases pH to levels between 8 and 9.5

                   • Controlled TDS release (40ppm vs 300ppm)

                   • Alkaline Filter Service Life of up to 3,000 gal.

                   • Filter replacement 12/18 mos.

 

 

 

 

WARNING: Do not use water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. This product is intended for the treatment of cold water only. Do not exceed 80 psi. This product is intended for residential use only.

 

NOTE: The HALO filtration systems are intended to treat potable water provided by municipal water providers. While the HALO Filtration Systems may be effective for treating well water, a well water quality analysis must be provided for review and recommendation to ensure optimum results. Failure to provide a current well water report to HALO Water Systems for analysis and recommendation voids all warranties. All filtration systems contain other parts that have a limited service life.

 

To prevent costly repairs or possible water damage, we strongly recommend periodically replacing the bowl or sump of all plastic housings: every 5 years for clear sumps and every 4 years for opaque sumps. If your sump has been used over the recommended period, it should be replaced immediately. Be sure to date any new replacement sump for future reference and indicate the next recommended replacement date.